Table of Contents
Advertisement
Opening the server
Caution! Before you proceed, make sure that you have turned
off your system and all peripherals connected to it. Read the
"Preinstallation instructions" on page 35.
You need to open the server before you can install additional
components. The bezel and left side panel are removable to allow
access to the system's internal components. Refer to the following
sections for instructions.
Removing the left-side panel
1
Observe the ESD precautions and pre-installation procedures
described on page 35.
2
Remove the bezel door and the bezel.
Refer to the preceding sections for detailed instructions.
3
Remove the left-side panel.
(1) Remove the two screws located at the end of the side
panel (1).
(2) Press the release button located on the left-side panel (2).
(3) Slide the side panel toward the rear of the chassis (3).
37
Advertisement
Table of Contents
