Table of Contents
Advertisement
48
(2) Attach the system's power cable to the SATA power cable
connector on the backplane (2).
Note: The SATA RAID backplane data cables must be installed and
removed in the following order: SATA0, SATA1, SATA2, and
SATA 3.
6
Observe the post-installation instructions described on page 36.
Important: When you are detaching the hot-plug cage from the
chassis, make sure to first remove all hard disks from their carriers.
For instructions, see "Installing an additional hard disk into the
hot-plug HDD cage carrier" on page 53.
3 System upgrade
Advertisement
Table of Contents
