To Set A Supervisor/User Password; To Change The Supervisor/User Password - Acer Altos G710 User Manual

Parameter
Change
Supervisor
Password
Password
Check
Keyboard Lock
Mode
Secure Mode
Hot Key

To set a Supervisor/User password

1 Use the up/down keys to highlight a password parameter
(Supervisor Password or User Password) then press Enter.
A password box will appear.
2 Type a password then press Enter.
The password may consist of up to six alphanumeric characters
(A-Z, a-z, 0-9).
3 Retype the password to verify the first entry then press Enter
again.
After setting the password, the system automatically sets the
chosen password parameter to Installed.

To change the Supervisor/User password

1 Use the up/down keys to highlight either change password
parameters (Change Supervisor Password or Change User
Password) then press Enter.
2 Type the original password then press Enter.
3 Type a new password then press Enter.
Description
Press Enter to change the Supervisor
password.
When this item is set to Setup, the
system will ask for the password every
time you run the BIOS Setup utility.
When set to Always, the system will
awalys ask for the password every
time it boots.
Enable or disables the keyboard lock
mode.
Select a key to be used to serve as hot
key in activating Secure Mode.
117
Option
Setup
Always
Disabled
Enabled
F11