Table of Contents
Advertisement
44
To install the easy-swap SCSI HDD cage
The easy-swap SCSI HDD cage is an optional four-bay internal HDD
enclosure without a SCSI backplane board.
1
Observe the ESD precautions and pre-installation procedures
described on page 35.
2
Remove the HDD cage bay cover. See page 39.
3
Remove the screw that secures the cover to the empty HDD bay,
then detach the cover.
4
Install the easy-swap cage.
(1) Hold the easy-swap cage with both hands, then slide the cage
into the housing. The cage is locked to the chassis with an
audible click.
(2) Locate and attach the following cables to their corresponding
connectors on the SCSI hard drive and SCSI RAID controller.
(1) SCSI data cable
3 System upgrade
Advertisement
Table of Contents
