Dish Network Solo ViP 411 User Manual page 79

To Use a Tuner or Amplifier's Volume Control
Note: You must first program the tuner or amplifier into the AUX mode of the remote
control to use these steps.
Press and hold the
AUX Mode button for
four seconds
(AUX flashes)
1
Press and hold the AUX button until all the mode buttons are lit, then let it go.
2
Press the POUND (#) button.
3
Press the PLUS side of the VOLUME button.
4
Press 0.
5
Press POUND (#). The AUX button flashes three times.
To confirm the VOLUME buttons are operating the tuner/amplifier's volume control, press
SAT and then try adjusting the volume. Your tuner/amplifier's volume should change
rather than your TV's volume.
To Use the TV's Volume Control
Press and hold the
TV Mode button for
four seconds
(TV flashes)
1
Press and hold the TV button until all the mode buttons are lit, then let it go.
2
Press the POUND (#) button.
3
Press the PLUS side of the VOLUME button.
4
Press 0.
5
Press POUND (#). The TV button flashes three times.
To confirm the VOLUME buttons are operating the TV's volume control, press SAT and
then try adjusting the volume. The TV's volume should change.
Remote Control Setup
Operating Other Devices
Press
POUND (AUX
button flashes
three times)
Press
POUND (TV
button flashes
three times)
69