Dish Network Solo ViP 411 User Manual page 75

Dish network hdtv satellite receiver
Hide thumbs Also See for Solo ViP 411:
Table of Contents

Advertisement

Learning From Another Device's Remote
Use this procedure if you are unable to find a code that allows your DISH Network remote
to control your device. This procedure is also applicable if after you have programmed
your DISH Network remote to control your device (in TV, DVD, or AUX modes), some of
the commands are not functioning as you expect. The learning function of your DISH
Network remote control can support these commands.
The remote control can learn commands in two ways:
You can follow the instructions for using equipment codes to program a specific mode, and
then learn commands that add new or overwrite existing functions of the remote control's
buttons in this mode. For this type of learning, any button without a learned command
keeps the previous command (if any) for that equipment code.
Each button on this remote learns a command from the equipment's original remote
control. For this type of learning, any button without a learned command keeps the
previous command (if any) for that equipment code.
To teach your DISH Network remote control specific commands for your equipment,
complete the following steps.
1
Ensure the DISH Network remote control is programmed to the desired remote address
(see Making the Remote Work with the Receiver).
2
Place both your DISH Network remote and the original equipment's remote control on a
flat, stable surface.
If you have found a code for that device, first program the code using the instructions for
Programming Using Device Code Tables or Programming Using Device Codes Scan. If
the device code has been programmed, press and release RECALL, then hold the
RECORD button for about three seconds until the mode button is lit again. The Mode
button remains lit while learning.
If the device code has not been programmed for that device or if you are unable to find a
code, press and hold the RECORD button for about three seconds until the mode button is
lit. The Mode button remains lit while learning.
Remote Control Setup
less than
3 inches
Operating Other Devices
65

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vip211Dish 411Vip 211k

Table of Contents