Additional Information - Dish Network 138410 User Manual

Set Up the Remote Control
You can set up the remote to control other devices using the device codes
listed on page 86. In the following instructions, the column on the left
contains the instructions and the column on the right provides additional
information.
Instructions
1. Turn the device on.
2. Find the brand name of the
device in the tables starting
on page 86.
3. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button. The mode
button flashes.
4. For AUX mode only. Press 0
for a second TV, or 1 for a
second VCR, or 2 for a tuner,
or amplifier.
5. Enter one of the three-digit
device codes from the table
using the NUMBER PAD
buttons.
6. If you want to program
Limited Mode, press 1. If not,
skip to step 7.
7. Press POUND (#).
8. Press POWER to turn off the
device. If the device does not
turn off, go to step 10.
9. Turn the device back on and
try some other buttons to
make sure they work. If the
code works for other buttons,
stop here.
10 If the code doesn't work, redo
steps 3 through 9 with another
device code from the tables.
Control Other Devices with the Remote

Additional Information

Use the device's front panel buttons
or its remote control.
If the brand isn't listed, see Setting Up
Using Device Codes Scan on page 86.
For example, hold TV for a TV until
all of the other mode buttons light.
When you let go, TV will flash.
This step is for programming which
kind of device that should be
programmed in AUX mode. If you're
not programming in AUX mode,
continue to step 5.
The three-digit device code should be
for the brand name of your device that
you found in step 2.
See Limited Mode for more
information.
If you entered the code correctly, the
mode button flashes three times.
If the code works, the device should
turn off.
Sometimes POWER works when
other buttons don't.
Try every code listed for your brand
until one works for your device.
Page 65