EchoStar Viaccess DVR-7000 User Manual page 16

Installation
Section 3
32. Wait for the search to complete:
a. the receiver display shows a moving dot;
b. the search completed popup menu appears.
33. On the RCU, press the OK key. to end the initial
setup procedure.
F
OR MOTORIZED INSTALLATIONS
CAUTION
On the motorized dish, set the physical East and West limit switches first. Failing to
do so might cause damage to your motorized dish installation or other properties.
22. Make the required selections.
23. Read the available help text for information.
Note that only the white fields are selectable,
other fields show reference information.
24. Go to the Autosat field.
25. On the RCU, press the OK key to advance.
26. On the RCU:
a. press the key to set the East limit;
b. at the motor error, press the key once;
c. press the OK key.
27. On the RCU, press the OK key.
28. Select a Eastern satellite which you can receive.
29. When in the location field:
a. press and hold the key and watch the signal
indicator for an indication;
b. in the signal indicator, make sure a network
name is shown;
c. press the key to select another transponder
for signal verification;
d. use the
level and quality;
e. press the key to select the location bar;
f. press the OK key, note that the saved position
of the satellite is shown.
30. Repeat the procedure for the middle and
Western Satellite.
31. Set the West limit ( key), refer to step 26.
32. Go to the Autosat field.
33. On the RCU, press the OK key to advance.
Page 3 - 6
- A
UTOSAT
key to fine tune for the best signal
EchoStar DVR-7000 Viaccess