KitchenAid Architect Series II KDRS505XSS Installation Instructions Manual page 21

30" (76.2 cm) double oven dual fuel ranges
Hide thumbs Also See for Architect Series II KDRS505XSS:
Table of Contents

Advertisement

Available languages

Available languages

2. Unscrew the hex-shaped regulator cap from the regulator and
remove the regulator pin.
A. Regulator pin
B. Regulator cap
3. Flip the regulator pin over and snap pin firmly into place.
A
A. LP gas position
B. Natural gas position
4. Screw the hex-shaped regulator cap securely back into place.
Do not overtighten.
To Convert Surface Burners
1. If installed, remove the burner grates.
2. Remove the burner caps.
3. Using a Phillips T20 Torx
base.
A
B
A. Burner cap
B. Gas tube opening
A
B
B
®
screwdriver, remove the burner
C
D
C. Burner base screws
D. Burner base
4. Apply masking tape to the end of a
help hold the LP gas orifice spud in the nut driver while
changing it. Press nut driver down onto the LP gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set the LP gas orifice spud aside.
A. LP gas orifice spud
Use the following chart for correct Natural gas orifice spud for
each burner. Refer to the model/serial rating plate behind the
control panel for proper sizing of Natural orifice spuds for each
burner location.
Natural Gas Orifice Spud Chart
Burner Rating
5,000 BTU
7,300 BTU
9,200 BTU
10,000 BTU
15,000 BTU
16,000 BTU
5. Replace the LP gas orifice spud with correct Natural gas
orifice spud. See the "Natural Gas Orifice Spud Chart."
6. Replace burner base and hand tighten the screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
9. Place LP gas orifice spuds in plastic parts bag for future use
and keep with literature package.
10. Replace burner grates.
11. Complete installation. See "Make Gas Connection" and
Electronic Ignition System" sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame ¼"
to ½" long. The outer cone is not as distinct as the inner cone.
Natural gas flames do not have yellow tips.
IMPORTANT: You may have to adjust the low setting for each
cooktop burner.
" (7.0 mm) nut driver to
A
Color
Number
Green
107N
Yellow
125N
Orange
142N
Transparent
149N
White
180N
Black
195N
21

Advertisement

Table of Contents
loading

Table of Contents