KitchenAid Architect Series II KDRS505XSS Installation Instructions Manual page 12

Style 2: Direct wire strain relief
Use Phillips screwdriver to remove screws and slide
cord/conduit plate down and out.
Position cord/conduit plate as shown in the following
illustration.
Replace cord/conduit plate and insert screws.
Assemble a UL listed conduit connector in the opening.
A. Removable retaining nut
B. Strain relief
12
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
Electrical Connection Options
A
B
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
Tighten strain relief screw against the flexible conduit.
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
If your home has: And you will be
connecting to:
4-wire receptacle A UL listed,
(NEMA type 14-50R) 250-volt
minimum,
40-amp, range
power supply
cord
4-wire direct A fused
disconnect or
circuit breaker
5" box
(12.7 cm)
3-wire receptacle A UL listed,
(NEMA type 10-50R) 250-volt
minimum,
40-amp, range
power supply
cord
3-wire direct A fused
disconnect or
1"
(2.5 cm)
circuit breaker
box
3"
(7.6 cm)
Go to Section:
4-wire connection:
Power supply cord
4-wire connection:
Direct wire
3-wire connection:
Power supply cord
3-wire connection:
Direct wire