Related Manuals for Dimplex Unvented Water Heater
Summary of Contents for Dimplex Unvented Water Heater
- Page 1 Dimp-15278-SCx_Instructions 31/3/06 9:32 am Page 1 DIMPLEX UNVENTED WATER HEATERS INSTALLATION MANUAL Marketing Department, Millbrook House, Grange Drive, Hedge End, Southampton, SO30 2DF. Telephone: 0870 077 7117 Fax: 0870 727 0109...
- Page 2 All your water – hot and cold – is direct from the mains TO BE LEFT WITH THE UNIT ● Site the SCx unvented water heater wherever convenient ● SCx fills your bath in minutes and will run two at the same...
- Page 3 Dimp-15278-SCx_Instructions 31/3/06 9:32 am Page 5 ● 1 Element on IDH indirect models up to 305 litres and 80 STANDARD ENERGY LOSSES litre DH direct model The heat loss of each SCx Unvented Unit while maintaining ● the temperature of the stored water at 65 degrees Celsius. 2 Elements on DH direct models from 130 up to 305 litres.
- Page 4 1 to the unit. Replacements can only be obtained from your authorised Dimplex Service Agent. All our heating elements have a built in manual reset cut-out. This will operate if the immersion heater thermostat fails.
- Page 5 Dimp-15278-SCx_Instructions 31/3/06 9:32 am Page 9 TUNDISH DRAINING The tundish supplied must be fitted visible to the occupier. The Switch off electrical power to immersion heaters and/or shut discharge pipe must be 22mm copper pipe. Regulations do down the boiler. Close the stopcock valve to isolate the SCx unit. not permit more than 3 x 90-degree bends between the SCx Attach hosepipe to the drain cock having sufficient length to unit and the outflow.
-
Page 6: Maintenance
MAINTENANCE ● To keep the cylinder in good operating order the cylinder should be serviced once a year by a Dimplex service engineer. ● If water is seen dripping through the tundish, please contact your installer or Dimplex service agent.