Table of Contents
Advertisement
Appendix A
Module Protocol Support
Channelized OCx/STMx Modules
Table 11: Channelized OCx/STMx Modules
Protocol or Application
Accepts traffic destined for GRE tunnels or DVMRP (IP-in-IP)
tunnels
APS/MSP
ATM (point-to-point)
BERT
This appendix lists the layer 2 and layer 3 protocols and applications that line modules
and their corresponding I/O modules support. Modules are identified by their physical
labels. See Table 1 on page 3 for a list of modules and their identifying labels.
The designation "not yet fully qualified" that appears in some tables in this appendix
indicates that support for the protocol or application on the specified module has
not yet been fully qualified by Juniper Networks. If you use a feature before it has
been fully qualified, it is your responsibility to ensure that it operates correctly in
your targeted configuration.
This appendix contains the following sections:
Channelized OCx/STMx Modules on page 107
Channelized T3 Modules on page 110
Ethernet Modules on page 112
OCx/STMx GE/FE Modules on page 118
OCx/STMx ATM Modules on page 120
OCx/STMx POS and OC48 Modules on page 123
Service Modules on page 125
Unchannelized E3 Modules on page 128
Unchannelized T3 Modules on page 130
cOCx FO Line Module with
cOC3/STM1 Modules
Yes
No
No
Yes
Channelized OCx/STMx Modules
cOCx FO Line Module with
cOC12/STM4 FO I/O Modules
Yes
Yes (single-mode intermediate
reach only)
No
Yes
107
Advertisement
Table of Contents
