Configure The Router - D-Link DSL-502G User Manual

Configure the Router

When you successfully connect to the web manager, the Home directory tab will display the Setup
Wizard menu. You can launch the Setup Wizard from this page or use the menu buttons located in
the left panel of the web page to view other menus used for basic configuration. You may use the
Setup Wizard if your Internet connection is a PPPoE connection. If you are using a PPPoE and
connection and want to use the Setup Wizard, follow the instructions below. If your Internet
connection is a Bridge or Static IP type connection, you should follow the instructions below in the
section Configure WAN Connection.
Click on a menu button
to use or view the menu
All configuration and management of the Router is done using the web-based management
interface pictured in the above example. The various menus accessed by clicking on one of the
directory tabs, Home, Advanced, Tools, Status and Help. Each tab displays menu buttons located in
the left hand panel of the web interface. The table below lists the menus for each directory in the
web manager.
Directory Configuration and Read-only Menus
Click the Home tab to access the Setup Wizard, WAN Configuration, LAN IP
Home
Configuration, DHCP for the LAN Setup and DNS Configuration menus.
Click the Advanced tab to access the UPnP, Port Forwarding, DMZ, IP/MAC Filters,
Advanced Firewall, NAT, ATM, Static Routing, Dynamic Routing (RIP) and Remote Access
menus.
DSL-502T ADSL Router User's Guide
Web Manager – First Time Log On
15
Click on a directory
tab to view the menus
available in that
directory
Click here to run
the Setup Wizard