Channel; Transpose - Kurzweil MICROPIANO Manual

Effect Wet/Dry Mix
8
The default setting for the EFFECTS mode
when the MicroPiano is turned on is ÒPrg.Ó
Remember, each program has its own pre-
determined effect, so changing a program when
in the PROGRAM mode will change the effect.
See pages 6 and 7 or the pull-out charts on pages
17 and 18, for a listing of the MicroPianoÕs pro-
grams and effects.
The Wet/Dry Mix of reverb can be adjusted
from your master controller by sending MIDI con-
troller 91 messages. Values 0-127 change the mix
from dry to wet.
The Wet/Dry Mix of chorus can be adjusted
from your master controller by sending MIDI con-
troller 93 messages. Values 0-127 change the mix
from dry to wet.
When you change the EFFECTS mode (either
through the front panel or through MIDI), the
Wet/Dry Mix is reset to the new effectÕs default.
Similarly, when you change the PROGRAM mode
while the EFFECTS mode is set to ÒPrg,Ó the
Wet/Dry Mix is reset to the new effectÕs default.

Channel

Press the Channel button then turn the Data knob
to select the MIDI channel to which your
MicroPiano will respond (1 - 16).
The default setting for the MIDI Channel is
Ò1Ó when the MicroPiano is turned on. The
MicroPiano responds to one channel at a time.
Note: will also appear in this display when
you turn the data knob past 16. See
page 5 for an explanation of the DEMO sequence.

Transpose

The MicroPiano can be transposed up or down
within a range of 24 semitones (± 2 octaves) by
using the Transpose button and then the Data
knob. Press the Transpose button and then
move the Data knob to the left or the right to
control the transposition.