Setting Up And Caring For Your; Micropiano; Mounting Your; To A Half-Rack Adapter - Kurzweil MICROPIANO Manual

Be sure to USE THE
SCREWS THAT COME
WITH THE UNIT.
They are " in length
3/8
and intended for use in
conjunction with the
rubber feet. If these
screws are misplaced,
do not substitute with
screws that are longer than
3/8" in length. If the screws
are longer than that, they
will hit electronic com-
ponents within the
MicroPiano and very
likely damage it.
2
SETTING UP AND CARING

MicroPiano

FOR YOUR
See the ÒImportant Safety and Installation
InstructionsÓ on the inside front cover for
important information as you set up and
turn on your MicroPiano.
Never take apart your MicroPiano. There
are no user-serviceable parts inside.
Clean your MicroPiano with a soft, dry cloth.
Do not use aerosol sprays on or near the
MicroPiano.
MicroPiano

Mounting Your

to a Half-Rack Adapter

The MicroPiano is a single-space, half-rack
module designed to Þt securely into any standard
19" equipment rack. For safety, do not turn on the
power source for other devices in your MIDI
system until the MicroPiano is connected.
If you desire to mount the MicroPiano in
your current equipment rack, Kurzweil recom-
mends you purchase a standard half-rack adapter
from your local dealer.
Enclosed with the MicroPiano are four screws
and four small adhesive-backed rubber feet for
mounting the unit to any half-rack adapter. Attach
the rubber feet as shown in the diagram on the
next page. The feet are required to be attached to
the MicroPiano, whether you mount it in a half-
rack adapter or sit it on a table.
To mount the MicroPiano to a half-rack
adapter, you must use the screws supplied. The
four holes in the bottom of the MicroPiano are
positioned such that they should line up with at
least two mounting holes in most standard
adapters.
See the illustration on the next page for more
mounting information.