Backup And Copy Functions - Kurzweil K2000 - GUIDE SUPPLEMENT - VERSION 3 Musician’s Manual Supplement

Disk Mode Enhancements in Version 3

Backup and Copy Functions

Backup and Copy Functions
The Backup and Copy functions have changed in Version 3 in order to support directories.
To access the Backup function, from the Disk mode page, first make sure that the Current Disk is
set to be the drive that you want to make a backup of. Next, press the Backup soft button:
Dir:\||||||||||||Sel:0/15||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||Set|backup|dir:ANIMALS|.KRZ||||1097K||
|||||||||||||||||BREAKAGE||||(dir)||||||
|||||||||||||||||LOWINST|||||(dir)||||||
Total:9040K||||||PLANKTON||||(dir)||||||
|Root||Parent|Open|||||||||Current|Exit|
On this screen, choose the directory tree that you want to backup by selecting a directory (see
Selecting Directories, near the beginning of this chapter.) Backup allows to you copy all of the
files within a directory tree from one disk to another. All of the files within the directory that you
choose, plus all of its subdirectories and files within them will be copied to the new drive. If you
want to backup the entire disk, then make sure the current directory is the root directory (as in
the picture), and press Current.
Next, you will see a dialog for choosing the destination disk:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||Destination|disk:SCSI|0|||||||||||||
|||||||||||||||||||||SCSI|1|||||||||||||
|||||||||||||||||||||SCSI|2|||||||||||||
|||||||||||||||||||||SCSI|3|||||||||||||
|||||||||||||||||||||||||||||OK|||Cancel
Select the disk you wish to transfer files to. It must be a different disk from the current disk.
Next, you can select a directory on the destination disk that will receive the transferred files.
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Use|default|directory|on|SCSI|0?||||||||
(Path|=|\)||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Change||OK|||Cancel
The default is always the root directory on the destination disk. Press OK to select the default.
To select a different directory, press Change.
4-60