Kurzweil K2000 - GUIDE SUPPLEMENT - VERSION 3 Musician’s Manual Supplement page 178

Disk Mode Enhancements in Version 3
Disk Utilities
directory (if no other files are selected). To use this function, press the Move soft button from the
Disk mode page. Then choose the file or files that you want to move:
Dir:\||||||||||||Sel:0/15||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||File|to|move:ATOMTOM|.KRZ||||||98K||
|||||||||||||||||BLOWFISH.KRZ||||||36K||
|||||||||||||||||COLORS||.KRZ|||||109K||
|Total:6846K|||||DRUMHITS||||(dir)||||||
Select||Root||Parent||Open|||OK|||Cancel
Press OK when you have made your selection. Press Cancel to return to the Disk mode page.
The K2000 remembers the most recent destination directory that a file was moved to. If the
current directory is different from the most recent destination directory, you will see the
question:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Use|default|directory|for|ATOMTOM.KRZ?||
(Path|=|\DRUMHITS\)|||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Change||OK|||Cancel
Press OK to use the default.
Press Change if you want to select a different destination from the default shown. The K2000
will then display a directory selection dialog (described early in this chapter), and you can select
the move destination directory from there:
Dir:\||||||||||||Sel:0/15||||Index:|||4|
|||||||||||||||||BLOWFISH.KRZ||||||36K||
|||||||||||||||||COLORS||.KRZ|||||109K||
|Select|dest|dir:DRUMHITS||||(dir)||||||
|||||||||||||||||EARTHLNG.KRZ|||||144K||
|||||||||||||||||HANDCLAP.KRZ|||||645K||
Total:6846K||||||INDUSTRY||||(dir)||||||
|Root||Parent|Open||Current|SetDir|Exit|
The move operation begins when you press either Current or SetDir.
If the default destination directory is the same as the source directory, the K2000 will skip the
Use default directory?
A good way to organize files into subdirectories, with a disk drive that was being used with
previous versions of K2000 software, is by using the Move command. First, create the
subdirectories you need, using the NewDir function. Then, use multiple file selection to select
the files to be grouped into a particular subdirectory. The files can be moved to their new
location in one operation.
4-58
prompt and instead go right to the Select dest dir: prompt.