Troubleshooting - Bissell 1623 User Manual

T
roubleshooting
Reduced Spray OR No Spray
Possible cause
1. Bladder may be empty
2. 2-in-1 water tank may not be seated properly.
3. Pump may have lost prime.
4. The pump belt may be broken.
A.
DirtLifter PowerBrush Does Not Turn
Possible cause
1. The brush belt or pump belt is off or broken.
Cleaner Not Picking Up Solution
Possible cause
1. Removable nozzle may not be properly attached.
2. 2-in-1 water tank lid is not properly installed.
3. 2-in-1 water tank is not properly seated.
4. 2-in-1 water tank has picked up maximum dirty water. 4. Empty tank and refill, refer to the
5. The lint screen may be clogged
Other maintenance or service not included in the manual should be performed by an
Thank you for selecting a BISSELL product.
Please do not return this product to the store
w w w . b i s s e l l . c o m
ug120-4039_1623E_508.indd 13 ug120-4039_1623E_508.indd 13
WARNING:
To reduce the risk of fire, electric
shock or injury, unplug from the
outlet before servicing.
Remedies
1. Turn power switch OFF; Refill bladder
with clean hand hot tap water.
2. Turn power switch OFF; remove and
reseat tank.
3. Turn power switch OFF; after 1 minute
turn ON and depress spray trigger.
4. Turn power switch OFF and unplug from
the outlet. To check if a pump belt has broken,
you will need a flat head screwdriver.
A. Insert the blade end into the slot of the
belt access door to release. Examine the
belt for breakage. You should be able to see
B.
the pump belt looped around the motor shaft.
If it is broken or missing, please refer to
Replacement Parts on page 15 before calling
BISSELL Consumers Services. Complete
installation instructions will accompany the
replacement belt.
B. When replacing belt access door be sure to
Slots Pump Belt
line up slots of belt access door with slots in
machine, slide door into place and snap shut.
Remedies
1. Refer to Remedy 4 above to check if brush
belt or pump belt is broken.
Remedies
1. Make sure nozzle is on correctly by slightly
raising front of machine to line up slots on the
base of the machine with the hooks on nozzle.
Attach at base first and then click nozzle into place.
2. Re-install lid; refer to the image on page 7.
3. Tank must be firmly seated to function;
Operation section.
5. Clean out lint screen. Refer to page 8.
authorized service representative.
remove and reseat tank.
5/19/08 12:30:04 PM 5/19/08 12:30:04 PM
13