Bissell 1623 User Manual page 8

Powerbrush select 220-240v
Hide thumbs Also See for 1623:
Table of Contents

Advertisement

O
peration
Carpet cleaning strokes
1.
Plug the deep cleaner into a proper outlet.
Turn the power ON by pressing the red power
switch on the back of the unit with your foot.
2.
With your foot, press the gray handle release
lever located on the back of unit below
water tank.
3.
While pressing the spray trigger, make one
slow forward wet pass and another back.
Let the BISSELL advanced deep cleaning
formula and DirtLifter PowerBrush do the
work for you. Caution: Do not overwet.
4.
Release the spray trigger and make one
slow forward and backward pass over the
same area to remove any residual dirty
water and aid in drying.
5.
Repeat cleaning passes until solution being
appears clean. Continue passes without
pressing the spray trigger until you can't
see any more water being suctioned up.
Empty the 2-in-1 water tank/clean removable nozzle
1.
Turn power switch OFF. Remove the 2-in-1
water tank from the base using the tank carry
handle. Carry the tank like a bucket to a utility
sink or outside where you will dispose of the
collection water. Remove the top of the tank
by rotating the handle forward to unlatch lid
and lifting lid off tank.
2.
Empty collection water from bottom of tank.
3.
After each use, remove and rinse the lint
screen located on the tank lid.
4.
If nozzle needs to be cleaned, remove by grasping
handle at the top and pulling forward. Clean
removable nozzle by rinsing under running water.
5.
When finished, replace nozzle by slightly
raising front of machine to line up slots on
the base with the hooks on nozzle. Attach at
base first and then click nozzle into place.
NOTE: If nozzle is not attached properly,
loss of suction will occur.
6.
To continue carpet cleaning, refer back to
pages 7 through 8, beginning with "Fill the
2-in-1 water tank" on page 7.
If cleaning is complete, refer to the
"Maintenance and care" section.
8
w w w . b i s s e l l . c o m
ug120-4039_1623E_508.indd 8
ug120-4039_1623E_508.indd 8
Tip:
Thorough vacuuming
before deep cleaning will prevent
early clogging of the lint trap.
Handle Release
WARNING:
To reduce the risk of fire and
electric shock due to internal
component damage, use only
BISSELL cleaning fluids intended
for use with the deep cleaner.
Non-BISSELL cleaning solutions
may harm the machine and void
the warranty.
1.
2.
Lint Screen
4.
3.
5.
Power Switch
5/19/08 12:29:54 PM
5/19/08 12:29:54 PM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents