January 20, 2010; Managing Multipath I/O; December 1, 2009; A.2.1 Managing Multipath I/O - Novell LINUX ENTERPRISE SERVER 11 - STORAGE ADMINISTRATION GUIDE 2-23-2010 Administration Manual

A.2 January 20, 2010
Updates were made to the following section. The changes are explained below.
Section A.2.1, "Managing Multipath I/O," on page 136

A.2.1 Managing Multipath I/O

Location
"Configuring Default Multipath Behavior
in /etc/multipath.conf" on page 59
getuid in Table 7-5, "Multipath Attributes,"
on page 62

A.3 December 1, 2009

Updates were made to the following sections. The changes are explained below.
Section A.3.1, "Managing Multipath I/O for Devices," on page 136
Section A.3.2, "Resizing File Systems," on page 137
Section A.3.3, "What's New," on page 137
A.3.1 Managing Multipath I/O for Devices
The following changes were made to this section:
Location
Section 7.2.3, "Using LVM2 on Multipath
Devices," on page 46
Section 7.9, "Configuring Multipath I/O
for an Existing Software RAID," on
page 70
prio_callout
Attributes," on page 62
136 SLES 11: Storage Administration Guide
in Table 7-5, "Multipath
Change
In the command line, use the path
default_getuid
as shown in the above example instead of
sbin/scsi_id
the sample path of
/lib/udev/scsi_id
sample file
/usr/share/doc/packages/multipath-
tools/multipath.conf.synthetic
default and annotated sample files).
Use the path
/sbin/scsi_id
udev/sbin_id that is in the sample file
packages/multipath-tools/
multipath.conf.synthetic
annotated sample files).
Change
The -f mpath option changed to -f multipath:
mkinitrd -f multipath
Multipath prio_callouts are located in shared libraries in
lib/libmultipath/lib*
callouts are loaded into memory on daemon startup.
/
that is found in the
file (and in the
instead of the path
/lib/
/usr/share/doc/
file (and in the default and
. By using shared libraries, the
/