June 10, 2008; Managing Multipath I/O; A.7.1 Managing Multipath I/O; March 20, 2008 (Sles 10 Sp2) - Novell LINUX ENTERPRISE SERVER 10 SP3 - STORAGE ADMINISTRATION GUIDE 2-23-2010 Administration Manual

A.7 June 10, 2008
Updates were made to the following section. The changes are explained below.
Section A.7.1, "Managing Multipath I/O," on page 131

A.7.1 Managing Multipath I/O

Location
Section 5.3.3, "Using mdadm for
Multipathed Devices," on page 52
"Verifying the Setup in the etc/
multipath.conf File" on page 56
A.8 March 20, 2008 (SLES 10 SP2)
Updates were made to the following section. The changes are explained below.
Section A.8.1, "Managing Multipath I/O," on page 131

A.8.1 Managing Multipath I/O

Location
Section 5.2.7, "Supported Architectures
for Multipath I/O," on page 47
Section 5.2.8, "Supported Storage Arrays
for Multipathing," on page 47
Section 5.4.5, "Creating and Configuring
the /etc/multipath.conf File," on page 56
Section 5.6, "Configuring Path Failover
Policies and Priorities," on page 60
Section 5.8, "Configuring Multipath I/O
for the Root Device," on page 67
Change
For information about modifying the
file, see Section 5.2.3, "Using LVM2 on Multipath Devices," on
page 46.
Use the -v3 option to show the full path list.
Change
This section is new.
This section was reorganized for clarity.
The /etc/multipath.conf
create it.
This section is new.
DM-MP is now available and supported for
in SUSE Linux Enterprise Server 10 SP1 and later if all online
updates have been applied. More specifically, you need
1.2-106.61 and
mkinitrd
or later.
/etc/lvm/lvm.conf
file does not exist unless you
and
/boot
0.4.7-34.23
multipath-tools
Documentation Updates 131
/root