Table of Contents
Advertisement
3.2.1 Using UUIDs to Assemble or Activate File System
Devices
The UUID is always unique to the partition and does not depend on the order in which it appears or
where it is mounted. With certain SAN devices attached to the server, the system partitions are
renamed and moved to be the last device. For example, if root (
the install, it might be assigned to
problem is to use the UUID in the boot loader and
The device ID assigned by the manufactuer for a drive never changes, no matter where the device is
mounted, so it can always be found at boot. The UUID is a property of the filesystem and can
change if you reformat the drive. In a boot loader file, you typically specify the location of the
device (such as
also mount devices by their UUIDs and administrator-specified volume labels. However, if you use
a label and file location, you cannot change the label name when the partition is mounted.
You can use the UUID as criterion for assembling and activating software RAID devices. When a
RAID is created, the
superblock.
3.2.2 Finding the UUID for a File System Device
You can find the UUID for any block device in the
UUID looks like this:
e014e482-1c2d-4d09-84ec-61b3aefde77a
3.3 Using UUIDs in the Boot Loader and /etc/
fstab File (x86)
After the install, you can optionally use the following procedure to configure the UUID for the
system device in the boot loader and
1 Install the SUSE
2 After the install, boot the system.
3 Open a terminal console as the
4 Navigate to the
installed
4a At the terminal console prompt, enter
cd /dev/disk/by-uuid
4b List all partitions by entering
ll
4c Find the UUID, such as
e014e482-1c2d-4d09-84ec-61b3aefde77a —> /dev/sda1
5 Edit
/boot/grub/menu.1st
For example, change
kernel /boot/vmlinuz root=/dev/sda1
32
SLES 10 SP3: Storage Administration Guide
/dev/sdg1
or
/dev/sda1
/dev/evms/sda1
driver generates a UUID for the device, and stores the value in the
md
/etc/fstab
®
Linux Enterprise Server for x86 with no SAN devices connected.
root
/dev/disk/by-uuid
,
, and
.
/boot
/root
swap
file, using the Boot Loader option in YaST2 or using a text editor.
) is assigned to
/
after the SAN is connected. One way to avoid this
files for the boot device.
/etc/fstab
) to mount it at system boot. The boot loader can
/dev/disk/by-uuid
files for your x86 system.
user or equivalent.
directory to find the UUID for the device where you
during
/dev/sda1
md
directory. For example, a
Advertisement
Table of Contents
Troubleshooting
