Song Loop; Tape - Alesis HR-16 Instruction Manual

hit. Th€se curves will also €ffect MlDl input trigg€ring of lh6 drums. In addition,
MlDl input velocity ssnsitivity allows 32 st€ps of volume control per drum when
us€d wilh gxl6rnal controll€rs such as drum pads or sequencers. Nol€, howevsr,
that recording MlDl input information on the HR-16 will only slore I steps of
velocity inside tha HR-16's internal record memory.
SONG LOOP
The SONG LOOP function turns on or off song looping. The display is as follows:
1 4
EI.IABLE:
The +/- arrow buttons are used to turn this function on or olf. The default is OFF.
When ON, a song that roaches its end will loop back to lh€ b€ginning of that song.
T A P E
The TAPE button is us€d to access tho tap€ int€rface f€atures of the HR-16. This
allows lhe us6r to save and rotrieve sequ€nce data with an ordinary casseil€
r€corder. Prossing and holding the TAPE bulton r€sults in the following display:
Pressing the RECORD button initiates th€ sav€ to tap€. Both buttons can now b€
releas€d, sinc€ thiE op€ralion may lake ov€r two minutes, during which th€
display will read:
PATT:00
Th€ display shows the currenl pattern or song being oulput. This display will
advance until all data is output. Pressing the STOP button will abort the
op€ralion. Bsforg pressing RECORD, lhe +/- arrow buttons can be used lo access
lhe other five tape pages. They are as follows:
LOAD ALL PATTS &
FROMTAPE:
T
AlesisHR-l6lnstructims ................... PagB 23