Migrating A Cluster Resource - Novell LINUX ENTERPRISE 11 - HIGH AVAILABILITY Manual

Procedure 4.11 Adding or Modifying Clones
1 Start the Linux HA Management Client and log in to the cluster as described in
Section 4.1, "Linux HA Management Client" (page 32).
2 In the left pane, select Resources and click Add > Clone.
3 Enter a unique ID for the clone.
4 Below Options, set the Initial state of resource.
5 Activate the respective options you want to set for your clone and click Forward.
6 In the next step, you can either add a Primitive or a Group as sub-resources for
the clone. These are created similar as described in Procedure 4.1, "Adding
Primitive Resources" (page 34) or Procedure 4.9, "Adding a Resource Group"
(page 50).
7 If all parameters in the clone configuration dialog are set according to your
wishes, click Apply to finish the configuration of the clone.

4.12 Migrating a Cluster Resource

As mentioned in Section 4.5, "Specifying Resource Failover Nodes" (page 43), the
cluster will fail over (migrate) resources automatically in case of software or hardware
failures—according to certain parameters you can define (for example, migration
threshold or resource stickiness). Apart from that, you can also manually migrate a re-
source to another node in the cluster resources manually.
Procedure 4.12 Manually Migrating Resources
1 Start the Linux HA Management Client and log in to the cluster as described in
Section 4.1, "Linux HA Management Client" (page 32).
2 Switch to the Management view in the left pane, then right-click the respective
resource in the right pane and select Migrate Resource.
Configuring Cluster Resources with the GUI 55