Configuring Websphere For J2Ee Agents - Novell ACCESS MANAGER 3.1 SP1 - AGENT GUIDE Manual

9 Specify a number for the Web Application Server installed. Specify 1 for WebSphere, then
press Enter.
10 Read the alert message and press Enter to continue.
11 Specify the directory where you have installed the WebSphere server. Press Enter to continue.
12 Review the installation summary, then press Enter to install the agent.
13 To verify the installation of the agent, see
on page

1.4.4 Configuring WebSphere for J2EE Agents

After you install the WebSphere application server, you must configure it for the J2EE Agent as
follows using the ConfigureWSAgent utility:
NOTE: You can run the ConfigureWSAgent utility multiple times, to configure multiple instances
of a WebSphere application server on a single physical machine.
1 Start the ConfigureWSAgent utility located at:
Linux/AIX: /opt/novell/nids-agents/bin
Windows: <Installation-directory>/nids-agents/bin
2 Ensure that WebSphere is running.
3 Review the License Agreement, accept it, then click Next. The Novell J2EE Agent
Configuration page is displayed.
4 Select the directory where the J2EE agent is installed and click Next. The Novell
Administration Server Communications Credentials page is displayed.
28 Novell Access Manager 3.1 SP1 Agent Guide
42.
Section 1.6, "Verifying If a J2EE Agent Is Installed,"