Installing The Websphere Agent Through The Console - Novell ACCESS MANAGER 3.1 SP1 - AGENT GUIDE Manual

14 Click Install to continue with the Agent installation.
15 Review the installation summary, then click Install to install the agent.
When installation is complete, The Configure IBM WebSphere Application Server Instance
page is displayed.
16 (Conditional) Select the Configure IBM WebSphere Application Server option to configure
application server instances and click Next. The configuration utility is launched. Complete the
configuration procedure in
page 28.
17 (Conditional) If you choose to perform the configuration at a later point of time, click Next. The
successful installation page is displayed.
18 Click Done to quit the installer.

1.4.3 Installing the WebSphere Agent Through the Console

1 Download the agent installer from
2 Enter the following command in the command prompt to run the installer on the console:
<filename> -i console
Replace <filename> with the name of the J2EE agent installer.
3 Review the License Agreement, then press
4 Specify an absolute path to install the Novell J2EE agent components, or press Enter to
continue with the default installation path.
5 Specify a Java Virtual Machine (JVM) to be used by the installed application.
All the available JVMs are displayed with a number. The default JVM is displayed with an
arrow. Press Enter to select the default JVM, or specify the number of one of the listed JVMs.
6 Specify the following information required for communication between the agent and the
Administration Console:
Specify the IP address of your Novell Access Manager Administration Console.
Specify the username and password of the admin user of the Novell Access Manager
Administration Console. Confirm the password by re-entering it.
Review the entered address. If your server is configured for more than one IP address,
make sure you specify the IP address of the machine from which the Novell Access
Manager administration console is reachable.
7 (Conditional) If you do not have the Audit server installed, J2EE installer installs the Audit
server for you. Specify the IP address of the Novell Access Manager Administration Console as
the Audit Server IP, then press Enter.
8 (Conditional) If the Audit server is already installed on your machine:
8a You are asked to specify if you want to replace the existing Audit server or use the existing
server.
Press 1 to use the existing Audit server.
Press 2 to replace the existing Audit server.
8b (Conditional) Press 1 to use the existing Novell Audit Configuration.
8c (Conditional) Press 2 to use a different Audit Server and then specify the IP address.
Section 1.4.4, "Configuring WebSphere for J2EE Agents," on
Novell (http://www.novell.com/products).
to accept it.
Y
Installing the J2EE Agents 27