NETGEAR DGND3700v1 User Manual page 57

N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
Select the Port Triggering radio button to display the port triggering information.
2.
Figure 24. Set up port triggering
Clear the Disable Port Triggering check box.
3.
If the Disable Port Triggering check box is selected after you
Note:
configure port triggering, port triggering is disabled. However, any
port triggering configuration information you added to the router is
retained even though it is not used.
In the Port Triggering Timeout field, enter a value up to 9999 minutes. This value controls
4.
the inactivity timer for the designated inbound ports. The inbound ports close when the
inactivity time expires. This is required because the router cannot be sure when the
application has terminated.
Click Add Service.
5.
Figure 25. Add a service for port triggering
In the Service Name field, type a descriptive service name.
6.
In the Service User field, select Any (the default) to allow this service to be used by any
7.
computer on the Internet. Otherwise, select Single address, and enter the IP address of
one computer to restrict the service to a particular computer.
Select the service type, either TCP or UDP or both (TCP/UDP). If you are not sure, select
8.
TCP/UDP.
In the Triggering Port field, enter the number of the outbound traffic port that will cause the
9.
inbound ports to be opened.
Security Settings
57