Pnp/Pci Configuration Setup - JETWAY 740DMR1A User Manual

Ring Power Up Control
MACPME Power Up Control
PCIPME Power Up Control
KB Power On Password
Power Up by Alarm
x Month Alarm
x Day of Month Alarm
x Time (hh:mm:ss) Alarm
↑ ↓ → ← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Ring/MACPME/PCIPME Power Up Control
During Disabled, the system will ignore any incoming call from the Modem/LAN/PCI
Devices. During Enabled, the system will boot up if there's an incoming call from the devices.
Power Up by Alarm
This function is for setting date and time for your computer to boot up. During Disabled, you
cannot use this function. During Enabled, choose the Date and Time Alarm:
Date(of month) Alarm
You can choose which month the system will boot up. Set to 0, to boot every day.
Time(hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
Note: If you have change the setting, you must let the system boot up until it goes to the
operating system, before this function will work.

3-9 PnP/PCI Configuration Setup

This section describes configuring the PCI bus system. PCI, or Personal Computer Interconnect, is a
system which allows I/O devices to operate at speeds nearing the speed the CPU itself uses when
communicating with its own special components. This section covers some very technical items and it
is strongly recommended that only experienced users should make any changes to the default settings.
CMOS Setup Utility – Copyright(C) 1984-2002 Award Software
Reset Configuration Data
Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
↑ ↓ → ← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Disabled
Disabled
Disabled
Enter
Disabled
NA
NA
0 : 0 : 0
F6:Optimized Defaults
PnP/PCI Configurations
Disabled
Manual
Press Enter
Disabled
Enabled
Enabled
F6:Optimized Defaults
31
Menu Level >>
F1:General Help
F7:Standard Defaults
Item Help
Menu Level >
F1:General Help
F7:Standard Defaults