Headers - JETWAY 625EMWR1A User Manual

setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
(11) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure two
hard disks to be both Masters using one ribbon cable on the primary IDE connector and
another ribbon cable on the secondary IDE connector.
•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.

2-6-2 Headers

(1) COM2 Serial Port Headers (9-pin) : COM2
This board has one serial port header COM2, it come with cable providing serial port
COM2. The On-board serial port can be disabled through BIOS SETUP. Please refer to
Chapter 3 "INTEGRATED PERIPHERALS SETUP" section for more detail information.
(2) TV-Out Header (5-pin): TV_OUT (for 625EMWxxx only)
The TV-Out header is for S-Video/Composite TV-Out function. With optional Cable
users can connect the TV and computer for TV-out function.
IDE1 IDE2
Pin 1 Pin 1
Note: Orient the read marking on the
COM2
COM2 ribbon cable to pin 1
Pin 1
13