Connectors, Headers; Connectors - JETWAY 601TCFR3A User Manual

Onboard VGA
AC97/MC97
Onboard USB
IMPORTANT!

2-6 Connectors, Headers

2-6-1 Connectors

(1) Power Connector (20-pin block) : ATX
ATX Power Supply connector. This is a new defined 20-pins connector that usually
comes with ATX case. The ATX Power Supply allows to use soft power on
momentary switch that connect from the front panel switch to 2-pins Power On
jumper pole on the motherboard. When the power switch on the back of the ATX
power supply turned on, the full power will not come into the system board until the
front panel switch is momentarily pressed. Press this switch again will turn off the
power to the system board.
(2) PS/2 Mouse & PS/2 Keyboard Connector: PS1
If you are using a PS/2 mouse, you must purchase an optional PS/2 mouse set which
connects to the 5-pins block and mounts to an open slot on your computer's case.
(3) USB Port connector: USB1
The connectors are 4-pins connector that connect USB devices to the system board.
(4) Parallel Port Connector (25-pin female): PRINT
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The On-
board Parallel Port can be disabled through the BIOS SETUP. Please refer to
Chapter 3 "INTEGRATED PERIPHERALS SETUP" section for more detail
information.
(5) VGA Connector (15-pin female): VGA



If using PCI cards on shared slots, make sure that the drivers support
"Shared IRQ" or that the cards don't need IRQ assignments. Conflicts will
arise between the two PCI groups that will make the system unstable or
cards inoperable.

Shared

Pin 1
PIN ROW2
1 3.3V 3.3V
2 -12V 3.3V
3 GND GND
4 Soft Power On 5V
5 GND GND
6 GND 5V
7 GND GND
8 -5V Power OK
9 +5V +5V (for Soft Logic)
10 +5V +12V
13
 
 

Shared
ROW1