JETWAY 601TCFR3A User Manual page 17

This connector is for on board VGA display connection only. If you insert any
external VGA card in PCI slot, you should have the connection to your VGA card's
connector. And you have to set "Init Display First" to PCI under Integrated
Peripherals option in BIOS Setup Utility to get display from PCI VGA card.
(6) Audio and Game Connector: AGC
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC and a 15-pin
D-Subminiature Receptacle Connector for joystick/MIDI Device.
Line-out :
Line-in :
MIC :
Game/MIDI :
(7) Serial Port COM1: COM1
COM1 is the 9-pin D-Subminiature mail connector. The On-board serial port can
be disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED
PERIPHERALS SETUP" section for more detail information.
(8) Floppy Drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting
the single plug end to motherboard, connect the two plugs at other end to the
floppy drives.
(9) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
Audio output to speaker
Audio input to sound chip
Microphone Connector
For joystick or MIDI Device
PS/2 MOUSE
PS/2 Keyboard
USB
PRINT GAME/MIDI PORT
COM1 VGA
Pin 1
Floppy Drive Connector
14
MIC
LINE-IN
LINE-OUT