Sony UTX-H2/U3032 - UWP Series Handheld Microphone Operating Instructions Manual page 37

To attach the holder clip to
the microphone
Push the holder clip against the bottom
of the microphone until the holder clip
clicks into place.
To take the slack out of the
microphone cable
Run the cable through the clamping
part of the holder clip.
To attach the wind screen to
the microphone
Insert the microphone into the hole at
the bottom of the windscreen.
To attach the belt clip
Insert one end of the belt clip into one of
two holes on either side of the
transmitter, and then insert the other end
into the hole on the other side.
To remove the belt clip
Insert a pointed object such as a ballpoint
pen between the belt clip and the
transmitter to make some space between
them, and then remove the end of the belt
clip from the hole on the side of the
transmitter.
Attachment and Installation Procedures 37