Fcc Compliance; Cleaning The Case; Cleaning The Screen; Water Immersion - Garmin GWS 10 Marine Wind Sensor Important Safety Information

Caring for the Unit
The case is constructed of high quality materials and does not
require user maintenance, except cleaning.

Cleaning the Case

Clean the unit's outer casing (except for the screen) using a
cloth dampened with a mild detergent solution and then wipe
dry. Avoid chemical cleaners and solvents that may damage
plastic components.

Cleaning the Screen

The unit's lens is coated with a special anti-reflective coating
that is sensitive to skin oils, waxes and abrasive cleaners.
Cleaners containing ammonia, alcohol, abrasives, or anti-
grease detergents will harm the anti-reflective coating. It is
important to clean the lens using an eyeglass lens cleaner
(that is specified as safe for anti-reflective coatings) and a
clean, lint-free cloth.

Water Immersion

The unit is waterproof to IEC Standard 60529 IPX7. It can
withstand immersion in 1 meter of water for 30 minutes.
Prolonged submersion can cause damage to the unit. After
submersion, be certain to wipe and air dry the unit before
reuse.
Declaration of Conformity
Hereby, Garmin declares that this product is in compliance
with the essential requirements and other relevant provisions
of Directive 1999/5/EC. To view the full Declaration of
Conformity, see the Garmin Web site for your Garmin
product: www.garmin.com.
Industry Canada Compliance
NOTE: The following statement does not apply to
fishfinders.
Category I radiocommunication devices comply with
Industry Canada Standard RSS-210. Category II
radiocommunication devices comply with Industry Canada
Standard RSS-310.

FCC Compliance

NOTE: The following statement does not apply to
fishfinders.
This product has been tested and found to comply with Part
15 of the FCC interference limits for Class B digital devices
FOR HOME OR OFFICE USE. These limits are designed
to provide more reasonable protection against harmful
interference in a residential installation, and are more
stringent than "outdoor" requirements.
Operation of this device is subject to the following
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired
operation.
This equipment generates, uses, and can radiate radio
frequency energy and may cause harmful interference to
radio communications if not installed and used in accordance
with the instructions. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet that is on a different
circuit from the GPS unit.
• Consult the dealer or an experienced radio/TV technician
for help.
This product does not contain any user-serviceable parts.
Repairs should only be made by an authorized Garmin
service center. Unauthorized repairs or modifications could
result in permanent damage to the equipment, and void your
warranty and your authority to operate this device under Part
15 regulations.
3