Activating Edit Mode - AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE) Instruction Manual

Designing Touch Panel Pages
General Button Categories (Cont.)
Decision buttons
Status buttons
Operation bars
Touch to Continue buttons
Joystick buttons
Bargraph buttons

Activating Edit Mode

Before designing touch panel pages and buttons, you must activate Edit mode. Once activated, use
the
EDIT
buttons. When powering up the touch panel, the first page is the Main page (FIG. 25). Note that the
Edit button is not available initially. If you have a pre-programmed panel, you may not see the Main
page.
FIG. 25 Main Page
To activate Edit mode:
1. Press
2. Press
28
button to enter Edit mode. This mode has options to add and configure touch panels and
in the Main page to open the Setup page (FIG. 26).
SETUP
to open the keypad.
PROTECTED SETUP
Decision buttons appear when an operation has two options and
requires verification before an action is performed.
Status buttons always have a dark fill with light letters and have no
functionality except to display information.
Operation bars appear in the place of the Editor bar, after selecting a
button or page edit operation. The operation bar indicates which edit
function is currently active. When an edit operation is selected, it
remains active until you press EXIT.
"Touch to Continue" buttons appear when an operation requires user
acknowledgement.
Joysticks are vertical and horizontal direction controllers for use with
pan and tilt camera controllers.
Bargraph buttons display a dynamic bargraph (vertical or horizontal).
An example is the Battery level indicator button.
4" Color Touch Panels with Audio