Table of Contents
Advertisement
INST ALLA TION OF LRM-5
Antenna Cable to Control Panel
Once the antenna is installed (the 3400 model has a Quick
Disconnect Interface Cable. Connect the cable from the radar
antenna to this cable. Tie this cable in knot similar to using
an electrical extension cord. Follow the remaining proce-
dure.), run the cable along the edge of the engine compart-
ment to the firewall. Find a location in the firewall where
other wires (or the speedometer cable) enter the passenger
compartment and feed the stereo jack connection through.
Be careful not to interfere with or disconnect other wires,
cables, or mechanical systems of your vehicle while routing
the antenna cable. Also, keep the antenna cable away from
any areas in the engine compartment that may become hot.
Cable ties are provided to secure the antenna and
Temperature Probe cables at various points in the engine
compartment.
General Information
The LRM-5 (Laser Receive Module) provides both front and
rear laser reception. Mount the LRM-5 with the 3-lens array
facing forward (down the road) and the single lens facing
behind. This approach offers the greatest protection, since
you will most often be traveling into a laser signal, rather that
away from it when laser speed enforcement is encountered.
For effective protection, make sure the LRM-5 has an unob-
structed view forward and behind, and that it is not placed
behind metallic sun screens.
Mounting the LRM-5
The LRm-5 can be mounted to the frount windshield using the
windshiled bracket supplied.
12
Advertisement
Table of Contents
