Troubleshooting Guide - DeWalt D24000 Instruction Manual

BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
MANY COMMON PROBLEMS CAN BE SOLVED EASILY BY UTILIZING THE CHART BELOW. FOR MORE SERIOUS OR
PERSISTENT PROBLEMS, CONTACT A D
TROUBLE! SAW WILL NOT START
WHAT'S WRONG?
1. Saw not plugged in
2. GFCI tripped
3. Saw will not run (plugged in; switch on)
4. Fuse blown or circuit breaker tripped
5. Cord damaged
6. Brushes worn out
TROUBLE! SAW MAKES UNSATISFACTORY CUTS
WHAT'S WRONG?
1. Dull cutting wheel
2. Water pump will not pump water
3. Cutting wheel mounted backwards
4. Build up on cutting wheel
5. Incorrect cutting wheel for work being done
TROUBLE! CUTTING WHEEL DOES NOT COME UP TO SPEED
WHAT'S WRONG?
1. Extension cord too small of a wire gauge or too long
2. Arbor loose
3. Low house voltage
TROUBLE! MACHINE VIBRATES EXCESSIVELY
WHAT'S WRONG?
1. Saw not mounted securely to stand
2. Stand or bench on uneven floor
3. Damaged saw cutting wheel
TROUBLE! DOES NOT MAKE ACCURATE CUTS
WHAT'S WRONG?
1. Edge guide not secure to fence
2. Cutting wheel is not square to fence
3. Cutting wheel is not perpendicular to cart surface
4. Workpiece moving

Troubleshooting Guide

WALT SERVICE CENTER OR CALL 1-(800)-4-D
E
WHAT TO DO...
1. Plug in saw.
2. Push switch to off and push reset button on GFCI.
3. Push switch to off and push the reset button on the GFCI.
4. Push switch to off and replace fuse or reset circuit breaker.
5. Have cord replaced by authorized service center.
6. Have brushes replaced by authorized service center.
WHAT TO DO...
1. Replace cutting wheel. See page 6.
2. Remove water pump and spray with clean
water to dislodge the impeller
3. Turn cutting wheel around. See page 6.
4. Use dressing stone to remove build up.
5. Change the cutting wheel. See page 6.
WHAT TO DO...
1. Replace with adequate size cord. See page 2.
2. Tighten arbor
3. Contact your electric company.
WHAT TO DO...
1. Reposition water pan on stand.
2. Reposition on flat level surface.
3. Replace cutting wheel. See page 6.
WHAT TO DO...
1. Check and adjust. See page 7.
2. Check and adjust. See page 9.
3. Check and adjust fence. See page 9.
4. Use edge guide.
11
WALT.
E