Advanced Routing - Linksys WRVS4400N User Manual

Business series wireless-n gigabit security router with vpn
Hide thumbs Also See for WRVS4400N:
Table of Contents

Advertisement

Setting Up and Configuring the Router
Setup Tab

Advanced Routing

Operating Mode
Select the Operating mode in which the Router will function.
Gateway—This is the normal mode of operation. This allows all devices on your LAN to share
the same WAN (Internet) IP address. In the Internet Gateway mode, the NAT (Network Address
Translation) mechanism is enabled.
Router—You either need another Router to act as the Internet Gateway, or all PCs on your LAN
must be assigned (fixed) Internet IP addresses. In Intranet Router mode, the NAT mechanism is
disabled.
Dynamic Routing
The Router's dynamic routing feature can be used to automatically establish a routing table
through a database exchange with peer routers (running the same routing protocol). The
Router supports RIP (Routing Information Protocol) versions 1 & 2.
RIP (Routing Information Protocol—The Router, using the RIP protocol, calculates the most
efficient route for the network's data packets to travel between the source and the destination
based upon the shortest paths.
RIP Send Packet Version—Choose the version of RIP packets you want to send to peers: RIPv1
or RIPv2. This should match the version supported by other Routers on your LAN.
RIP Recv Packet Version—Choose the version of RIP packets you want to receive from peers:
RIPv1 or RIPv2. This should match the version supported by other Routers on your LAN.
WRVS4400N User Guide
42

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents