Port Settings - Linksys WRVS4400N User Manual

Setting Up and Configuring the Router
L2 Switch Tab

Port Settings

Port—Specifies the number of the four LAN ports.
Link—Displays the port duplex mode (Full or Half ) and speed (10/100/1000 Mbps). Full
indicates that the interface supports transmission between the device and its link partner in
both directions simultaneously. Half indicates that the interface supports transmission
between the device and the client in only one direction at a time.
Mode—Specifies port duplex mode (Full or Half ) and speed (10/100/1000 Mbps). Auto
Negotiation is a protocol between two link partners that enables a port to advertise its
transmission rate, duplex mode and flow control abilities to its partner. Default is Auto
Negotiation.
Flow Control—Configures the flow control setting on the port. Select to enable. The default is
disabled.
MaxFrame—Configures the maximum ethernet frame size sent or received on the port.
Default is 1518. You can set only to a value lower than 1518.
Change these settings as described here and click Save Settings to apply your changes, or click
Cancel Changes to cancel your changes. Help information is displayed on the right-hand side
of the screen, and click More for additional details.
WRVS4400N User Guide 99