Rear View - VINCENT SP-998 Instructions For Use Manual

3. LINE IN: Input for
preamplified mono audio signal
One connector of this input must be connected with
the output connector of the preamplifier for the desi-
red channel. For example, connected with "PRE
OUT R", if the SP-998 is to be used for the loud-
speaker of the right-hand stereo channel. Only one
of the two input connectors can be used at any
time. The setting "XLR/RCA" must be chosen cor-
rectly. Do not connect any line level sources!
4. SPEAKERS: Loudspeaker terminals
At these output sockets with threaded terminals one
or two loudspeakers can be connected. Speaker
cable with 4 mm banana plugs can be used.
5. POWER CONTROL: ON/OFF control
These jack connectors (3.5 mm) receive and for-
ward the signal for the standby control (12V
Trigger). If the POWER switch is in the "off" posi-
tion, the SP-998 is activated or deactivated
depending on the signal received at one of these
connectors. The other connector forwards the
signal to another device of connected.
6. FUSE: Fuse holder
This small plastic housing holds the fuse. Refer to
the security precautions.
7. AC: Power Connector
To establish the power supply, connect the plugs
of the power cable to the device and to a suitab-
le wall outlet.
Vincent
24

REAR VIEW

3
5
4
6 7