Exit Selecting - TYAN TOMCAT I875PF User Manual

Tomcat i875PF S5105
Type the password, up to eight characters in length, and press <Enter>. The password typed
now will clear any previously entered password from CMOS memory. You will be asked to
confirm the password. Type the password again and press <Enter>. You may also press
<Esc> to abort the selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter the password. A
message will confirm the password will be disabled. Once the password is disabled, the
system will boot and you can enter Setup freely.
When a password has been enabled, you will be prompted to enter it every time you try to
enter Setup. This prevents an unauthorized person from changing any part of your system
configuration.
Additionally, when a password is enabled, you can also require the BIOS to request a
password every time your system is rebooted. This would prevent unauthorized use of your
computer.
You determine when the password is required within the BIOS Features Setup Menu and its
Security option (see Section 3). If the Security option is set to "System", the password will be
required both at boot and at entry to Setup. If set to "Setup", prompting only occurs when
trying to enter Setup.
3.13 – Exit Selecting
► Standard CMOS Features
► Advanced BIOS Features
► Advanced Chipset Features
► Integrated Peripherals
► Power Management Setup
► PnP/PCI Configurations
► PC Health Status
Esc: Quit
F10: Save & Exit Setup
Save & Exit Setup
Pressing <Enter> on this item asks for confirmation:
PASSWORD DISABLED.
Phoenix – AwardBIOS CMOS Setup Utility
Enter Password:
Change/Set/Disable Password
Save to CMOS and EXIT (Y/N)? Y
http://www.tyan.com
► Frequency/Voltage Control
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
↑ ↓ ← →: Select Item
46
Chapter 3: BIOS Setup