TYAN TOMCAT I875PF User Manual page 36

Tomcat i875PF S5105
OnChip IDE Device:
IDE HDD Block Mode
On-Chip Primary
IDE Primary Master PIO
IDE Primary Slave
IDE Primary Master UDMA
IDE Primary Slave
On-Chip Secondary PCI IDE
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
**On-Chip Serial ATA Setting**
SATA Mode
On-Chip Serial ATA
Serial ATA Port0 Mode
Serial ATA Port1 Mode
↑↓←→: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
IDE HDD Block Mode:
Leave this setting as is.
Enabled / Disabled
On-Chip Primary PCI IDE:
The integrated peripheral controller contains an IDE interface with support for two IDE
channels. Select "Enabled" to activate each channel separately.
Enabled / Disabled
Primary / Secondary Master/ Slave PIO:
The four IDE PIO (Programmed Input / Output) field let you set a PIO mode (0-4) for each of
the four IDE devices that the onboard IDE interface supports. Modes 0 through 4 provide
successively increased performance. In Auto mode, the system automatically determines the
best mode for each device.
Auto / Mode 0 / Mode 1 / Mode 2 / Mode 3 / Mode 4
Primary / Secondary Master/ Slave UDMA:
This allows you to select the mode of operation for the Ultra DMA/33 implementation is
possible only if your IDE hard drive supports it and the operating environment includes a DMA
driver (Windows 95 OSR2 or a third-party IDE bus master driver). If your hard drive and your
system software both support Ultra DMA/33, select Auto to enable bios SUPPORT.
Auto / Disabled
Phoenix – AwardBIOS CMOS Setup Utility
OnChip IDE Device
[Enabled]
PCI IDE [Enabled]
[Auto]
PIO [Auto]
[Auto]
UDMA [Auto]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
IDE
[Auto]
[SATA 0 Master]
SATA 1 Master
http://www.tyan.com
_________________________
Menu Level ►►
33
Chapter 3: BIOS Setup
Item Help