TYAN TIGER 100 Manual page 65

Default Settings Chart (Continued)
Setting Option
* I R R ecei ver P i n
O nboar d P ar al l el P or t
P ar al l el P or t M ode
* EP P Ver si on
P ar al l el P or t I R Q
* P ar al l el P or t D M A C hannel
O nboar d I D E
* Setting Option is not Selectable
Overclock Warning Message
When enabled, this option sends a warning message if the CPU is
overclocked. The settings are Enabled or Disabled.
LM79 IN(X)
This option specifies various CPU core voltage settings.
Power Interruption
The settings are Enabled or Disabled.
Onboard FDC
Set this option to Enabled to enable the floppy drive controller on the mother-
board. The settings are Auto, Enabled, or Disabled.
Onboard Serial Port1
This option specifies the base I/O port address of serial port 1. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Onboard Serial Port2
This option specifies the base I/O port address of serial port 2. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Serial Port2 Mode
This option specifies the operating mode for serial port 2. This option will not
appear if the Onboard Serial Port2 option is set to Disabled, or is set to Auto
and your system does not have an onboard serial port 2. The settings are
Normal, Sharp-IR, IrDA, and Consumer.
S1832DL Tiger 100
Optimal Default Fail-Safe Default
I R R X1 I R R X1
378 378
N or m al N or m al
N / A N / A
7 7
N / A N / A
B ot h B ot h
65