Connecting Onkyo Ri Components - Onkyo HT-RC470 Instruction Manual

Connecting Onkyo RI Components

1
Make sure that each Onkyo component is connected
with an analog audio cable (connection
hookup examples) (➔ page 16).
2
Make the connection (see the illustration).
3
If you're using an RI Dock, or cassette tape deck,
change the Input Display (➔ page
With (Remote Interactive), you can use the following
special functions:
■
System On/Auto Power On
When you start playback on a component connected via
, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected via
, the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver's remote controller to
control your other -capable Onkyo components,
pointing the remote controller at the AV receiver's
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(➔ page 74).
in the
43).
e.g., cassette tape deck
Note
• Use only cables for
with Onkyo components.
• Some components have two
one to the AV receiver. The other jack is for connecting
additional -capable components.
• Connect only Onkyo components to
manufacturer's components may cause a malfunction.
• Some components may not support all
manuals supplied with your Onkyo components.
• While Zone 2/3 is on, the System On/Auto Power On and Direct
Change functions do not work.
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
RI Dock
connections. cables are supplied
jacks. You can connect either
jacks. Connecting other
functions. Refer to the
En-17
Connections