Zenith 32LC2DA Installation And Operating Manual page 26

Installation
When RGB connect to PC input and select the RGB-PC. this function is used.
When HDMI/DVt connect to PC input and select HDMI/DVI input, this function is used,
- After connecting RGB-PC or HDMI/DVI to PC input and checking the screen quality,
* Adjustment for screen Resolution, Position, Size, and Phase
Position This function is to adlust
Dcture to left/tight and
up/down as you pref_.r.
Size This function is to minimize
ground. And the horizontal
screen size will also
change,
Phase This function allows you to
remove _qy horizontaJ noise
and c_ear or sharpen the
_mage of characters.
Resolution This function allows you
select Resolution of
XG A£¢/× GAo
!
2
Press the ADJUST button and then use A / Y button to select
Resolution_ POSITION SIZE, or PHASE
Press ENTER button and then use A / T / 4
make appropriate adjustments,
- The PHA_ adiustment range is -16 - +16.
dn HDMI/DVFPC mode. PHASE is not available,)
• The S_ adjustment [ange _s-30 _ +30,
tf_nHDMI/DVFPC mode _ is not availaMe.
I_ buttons to
* When you change the resolution, select the proper resolutio_
in present input to see the best picture appearance.
* Initializing (Reset to original factory values)
To initialize the adjusted values
1
2
3
Press the ADJUST button and then use & ,,' T button to select
the P_ESET option,
Press ENTER button and then use 4 / I_ button to select Yes
Press ENTER button.
26