To Turn Off Gas To Appliance - Vanguard VI33NR VI33PR Owner's Operation And Installation Manual

OPERATING FIREPLACE
INSERT
Continued
10. Wait one minute and switch selector switch to the ON posi-
tion to light burners.
11. Set flame adjustment knob to any level between HI and LO.
CAUTION: Do not try to adjust heating levels by
using the equipment shutoff valve.
WARNING: Make sure the selector switch is in the
OFF position when you are away from home for long
periods of time. Heater will come on automatically
with selector switch in the ON position.
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
1. Turn control knob clockwise
2a. Set selector switch in the OFF position.
2b. If Using Optional Hand-Held Remote: Set remote selector
switch in the OFF position to keep from draining battery.
Shutting Off Burners Only (pilot stays lit)
You may shut off the burners and keep the pilot lit by doing one
of the following:
• Turn control knob clockwise
• Use remote control manual OFF button.
• Set remote selector switch in the OFF position.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under Lighting Instructions, pages
16 and 17.
2. Depress control knob and light pilot with match.
3. Keep control knob pressed in for 30 seconds after lighting
pilot. After 30 seconds, release control knob. Now follow
steps 9 through 11, pages 16 and 17
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be purchased sepa-
rately (see Accessories, page 30). Follow instructions included
with the remote control.
NOTICE: You must light the pilot before using the
hand-held remote control unit. See Lighting Instruc-
tions on pages 16 and 17.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111285-01B
1. After lighting, let pilot flame burn for about one minute.
Flame Adjustment Knob
to the OFF position.
Figure 34 - Setting the Remote Selector Switch, Control Knob,
and Flame Adjustment Knob for Remote Operation
ON/OFF SERIES (MODEL GHRCB)
Hold the control button on the hand-held remote until burner
to the PILOT position.
turns on. Hold the control button again until burner turns off
(see Figure 35).
TO LOCK
light stops flashing. Hand-held remote control is now locked. If
the fire is on it will be turned off automatically. In the locked
state, the light will not light up when any button is pressed.
TO UNLOCK
control until the light stops flashing. The hand-held remote is
now unlocked.
Figure 35 - On/Off Hand-Held Remote Control Unit (GHRCB)
OPERATING FIREPLACE INSERT
Lighting Instructions (Cont.)

To Turn Off Gas To Appliance

Manual Lighting Procedures
Optional Hand-Held Remote Operation
Turn control knob to ON position. Adjust flame adjustment
knob anywhere between HI and LO. Slide the selector switch
to the REMOTE position (see Figure 34). Note: The burner
may light if hand-held remote was on when selector switch
was last turned off. You can now turn the burner on and off
with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch in the RE-
MOTE or ON position when the pilot is not lit. This will
drain the battery.
Control Knob in
Remote Selector Switch in Remote Position
On Position
(Optional Hand-Held Remote Control)
press both buttons on hand-held remote control until
press both buttons together on hand-held remote
17
17
ON
OFF
REMOTE
Control Button
Turns Burners
On and Off