Wiring Diagram; To Turn Off Gas To Appliance - Vanguard MDVFST Owner's Operation And Installation Manual

Direct-vent gas fireplace
Table of Contents

Advertisement

MDVFST DIRECT-VENT GAS FIREPLACE
OPERATING
FIREPLACE
Continued
TO TURN OFF GAS
TO APPLIANCE
1.
Turn off remote control or wall
switch.
2. Turn off all electric power to the ap-
pliance if service is to be performed.
3. Remove control access panel.
4. Push in gas control knob slightly and
turn clockwise
not force.
5. Replace control access panel.
Note: It is recommended that you main-
tain the gas control knob in the full "OFF"
position during lengthy periods of sea-
sonal non-usage.
REMOTE
OPERATION
Follow instructions included with the re-
mote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions , page 19.
Lighting Instructions
1.
After lighting, let pilot flame burn for
about one minute. Turn control knob
to ON position. Slide the selector switch
to the REMOTE position. Note: The
burners may light if hand-held remote
ON button was on when selector switch
was last turned off. You can now turn
the burners on and off with the hand-
held remote control unit.
IMPORTANT: Do not leave the se-
lector switch in the REMOTE posi-
tion when the pilot is not lit. This will
drain the battery.
IMPORTANT: Be sure to press the
ON/OFF buttons on the hand-held
remote control unit for up to 3 sec-
onds to assure proper operation.
2. Press ON/OFF button to turn the
burners on and off. When turning
burners off, the pilot will remain lit.
®
Piezo Ignitor
Thermocouple
Figure 52 - Pilot
to "OFF". Do
Figure 53 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Remote Operation

WIRING DIAGRAM

Thermocouple
Incoming
Main
Gas
Supply
Pilot Burner
Thermopile
Control Knob in
On Position
ON
OFF
REMOTE
Selector Switch in
Remote Position
Pilot
Piezo Ignitor
Thermopile
Pilot
Gas Line
TH
Control
TP
Valve
TH/TP
Variable
Speed
Electrical Rating:
Control
120v, 60Hz, 0.7A
20
Piezo Ignitor
Do Not
Connect
To 120V
N.O.SW
Remote
(Wall Switch)
Control
Wireway
GND
N.O.SW
Field Wire
BLK
Incoming
120V AC
WHT
(Fuse Box
or
GRN
Breaker)
Connectors
(Not Supplied)
106442

Advertisement

Table of Contents
loading

Table of Contents