Local Codes - Vanguard VI33NR VI33PR Owner's Operation And Installation Manual

Unvented (vent-free) gas fireplace insert
Hide thumbs Also See for VI33NR VI33PR:
Table of Contents

Advertisement

SAFETY INFORMATION
Continued
Keep the appliance area clear and free from combus-
tible materials, gasoline, and other flammable vapors
and liquids.
Carefully supervise young children when they are in the
room with fireplace. When using the hand-held remote
accessory, keep selector switch in the OFF position to
prevent children from turning on burners with remote.
You must operate this fireplace insert with the fire-
place insert screen and hood in place. Make sure
fireplace insert screen and hood are in place before
running fireplace insert.
1. This appliance is only for use with the type of gas indicated on
the rating plate. This appliance is not convertible for use with
other gases.
2.
Do not place propane/LP supply tank(s) inside any structure. Lo-
cate propane/LP supply tank(s) outdoors (propane/LP units only).
3. If you smell gas
• shut off gas supply
• do not try to light any appliance
• do not touch any electrical switch; do not use any phone in
your building
• immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions
• if you cannot reach your gas supplier, call the fire department
4.
This fireplace insert shall not be installed in a bedroom or bathroom.
5. Do not use this fireplace insert as a wood-burning fireplace.
Use only the logs provided with the fireplace insert.
6. Do not add extra logs or ornaments such as pine cones, ver-
miculite, or rock wool. Using these added items can cause soot-
ing. Do not add lava rock around base. Rock and debris could
fall into the control area of fireplace insert.
7. This fireplace insert is designed to be smokeless. If logs ever ap-
pear to smoke, turn off fireplace insert and call a qualified service
person. Note: During initial operation, slight smoking could oc-
cur due to log curing and burning of manufacturing residues.
8. To prevent the creation of soot, follow the instructions in Clean-
ing and Maintenance, page 20.
9. Before using furniture polish, wax, carpet cleaner, or similar
products, turn heater off. If heated, the vapors from these prod-
ucts may create a white powder residue within burner box or
on adjacent walls or furniture.
10. This fireplace insert needs fresh air ventilation to run properly.
This fireplace insert has an Oxygen Depletion Sensing (ODS)
safety shutoff system. The ODS shuts down the fireplace in-
sert if not enough fresh air is available. See Air for Combus-
tion and Ventilation, pages 5 through 7. If fireplace insert keeps
shutting off, see Troubleshooting, pages 22 through 24.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111285-01B
SAFETY INFORMATION
11. Do not run fireplace insert
• where flammable liquids or vapors are used or stored
• under dusty conditions
12. Do not use this fireplace insert to cook food or burn paper or
other objects.
13. Do not use fireplace insert if any part has been exposed to or
under water. Immediately call a qualified service technician to
inspect the fireplace insert and to replace any part of the con-
trol system and any gas control which has been under water.
14. Do not operate fireplace insert if any log is broken. Do not
operate fireplace insert if a log is chipped (dime-sized or larger).
15. Turn fireplace insert off and let cool before servicing. Only a quali-
fied service person should service and repair fireplace insert.
16. Operating fireplace insert above elevations of 4,500 feet could
cause pilot outage.
17. To prevent performance problems with propane/LP units, do
not use propane/LP fuel tanks of less than 100 lb. capacity
(propane/LP units only).
18. Provide adequate clearances around air openings.
19. Trim panels and surrounds must not seal ventilation openings
in fireplace.
20. Cutting any sheet-metal parts of the solid-fuel burning fire-
place or listed ventless firebox enclosure in which the vent-
free fireplace insert is to be installed is prohibited.
21. If the factory-built fireplace has no gas access hole(s) provided,
an access hole of 1.5 inch (37.5 mm) diameter or less may be
drilled through the lower sides or bottom of the firebox in a proper
workmanlike manner. This access hole must be plugged with non-
combustible insulation after the gas supply line has been installed.
22. Refractory, glass doors, screen rails, screen mesh and soldi-
fuel log grates (if applicable) can be removed from the fire-
place before installing the unvented fireplace insert.

LOCAL CODES

Install and use fireplace insert with care. Follow all local codes. In
the absence of local codes, use the latest edition of The National
Fuel Gas Code ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
3 3
LOCAL CODES

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vi33nrVi33pr

Table of Contents