Ulead VIDEO STUDIO 7 Manual page 27

VIDEOSTUDIO HELP
Table of Contents | Index
The Navigation Panel
The Navigation Panel is used to preview and edit the clips used in
your project. Use the Navigation Controls to move around a
selected clip or your project. Use the Trim Bar and Jog Bar to edit
your clips.
When capturing video, the set of buttons will differ. Instead of the
Navigation Panel, device control buttons will be shown. Use these
buttons to control your DV camcorder or any other video device.
Home
Returns to the
starting point of a
project, clip, or
selected area.
Mark-in / out
Use to mark the point
where you want a clip
to start and end.
Play mode
Select whether you
want to preview your
entire project or only
the selected clip.
Play
Click to play a
VideoStudio project,
video or audio clip.
Hold down the
[Shift] to play only
the selected duration
(between Mark in and
Mark out) on the
Trim Bar. During
playback, click the
button again to stop.
End
Next
Moves to the
Moves to the point
ending point of a
right after the
project, clip, or
present point of a
selected area.
project, clip, or
selected area.
Trim Bar
Used for trimming,
editing, and
cropping video clips.
Previous
System Volume
Moves to the
Click and drag the
preceding point of
slider to adjust the
a project, clip, or
volume of a clip's
selected area.
audio output or
music. This adjusts
the volume of your
speakers at the
Repeat
same time.
Plays a project,
clip, or selected
Jog Bar
area continually.
Click and drag
these controls to
scroll through a
clip. The position is
shown in the
Preview Window's
content.
27
Back
Timecode
Allows you to directly
jump to a part of your
project or selected clip
by specifying the exact
timecode.
Enlarge Preview
Window
Click to preview your
project or clip on a
bigger window.
Split Video
Cuts the selected clip
into two. Position the
Jog Bar to where you
want the first clip to
end and the second
one to start, then click
this button.
Undo and Redo
Any changes you make
that you don't like can
be instantly fixed or
undone by clicking the
left button. And if you
change your mind,
simply click Redo.