Local Codes; Unpacking; Product Features - Desa CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB Owner's Operation And Installation Manual

LOCAL CODES

Install and use fireplace with care. Follow all local
codes. In the absence of local codes, use the lat-
est edition of The National Fuel Gas Code, ANSI
Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269

UNPACKING

CAUTION: Do not remove the
data plates attached to the heater
base assembly. The data plates
contain important warranty and
safety information.
1. With utility knife, cut the carton all the way
around above the staples on the bottom tray.
Lift the carton off the heater. Remove packing.
Note: The hood is located in the packing on
the right hand side of the heater front. Lift the
heater off the bottom tray.
2. Locate two screws above top corners of the
fireplace screen. Remove and discard these
screws. Lift fireplace screen up and pull out
to remove.
3. Remove protective packaging applied to logs,
log base assembly and fireplace.
4. Remove fireplace hood from carton insert.
5. Check all items for any shipping damage. If
damaged, promptly inform dealer where you
bought fireplace.
111245-01B

PRODUCT FEATURES

OPERATION
This vent-free fireplace is clean burning. It requires
no outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by both
realistic flames and glowing embers. When used
without the optional blower, the fireplace requires
no electricity making it ideal for emergency
backup heat.
SAFETY DEVICE
This fireplace has a pilot with an Oxygen Depletion
Sensing (ODS) safety shutoff system. The ODS/
pilot is a required feature for vent-free room heat-
ers. The ODS/pilot system shuts off the fireplace
if there is not enough fresh air.
PIEZO IGNITION SYSTEM
This fireplace has a piezo ignitor. This system
requires no matches, batteries or other sources to
light fireplace.
WIRELESS REMOTE CONTROL
This fireplace features an infrared wireless remote
control. This control system can be used to auto-
matically light the pilot and adjust the burner flame
height at the push of a button.
WIRED WALL-MOUNTED REMOTE
CONTROL
This fireplace features a two-button wall switch as-
sembly with glowing LEDʼs. The wall switch per-
forms the same functions as the wireless hand-held
remote control with the added feature of LEDʼs for
visual feedback of operation and status.
OPTIONAL BLOWER ASSEMBLY
ACCESSORY
This fireplace accepts an optional blower assembly
(not included). The GA3650T/GA3700T Series
blower operates thermostatically and features a
variable speed control. The GA3700/GA3750
Series operates manually and also features a vari-
able speed control. The blower circulates heated
air from the fireplace into the room. Use of blower
is optional. See Accessories, page 40.
www.desatech.com 5