Desa CGEFP33PRB, CGEFP33NRB, EFP33PRB, EFP33NRB Owner's Operation And Installation Manual page 12

INSTALLATION
Continued
8. Remove paper template from wall.
9. Drill 3/8" holes at each mark.
10. Using a straight edge and pencil, connect the
outer edges of the 4 holes for the rectangle (see
Figure 10). This will give you cutting lines for
the rectangle you will cut in the wall.
11. Using a keyhole saw, hack saw blade, drill,
file or other suitable tool, carefully cut out the
rectangular opening. Note: The corners of the
rectangle may be round. IMPORTANT: Do not
exceed the size of the rectangle on template.
12. From inside the recessed opening for the
fireplace, carefully pass wall switch assembly
through the rectangular opening to the outside
of the wall.
13. Using wall anchors supplied in hardware pack-
age, fold wall anchor as shown in Figure 11.
14. Insert wall anchor, wings first, into hole. Tap
anchor flush to wall.
15. For thin walls (1/2" or less), insert red key into
wall anchor. Push red key to "pop" open anchor
wings. See Figure 12. IMPORTANT: Do not
hammer key! For thick walls (over 1/2" thick),
do not pop open wings.
4 3 /
4
12
3/8"
Diameter
2 Holes
3/4"
"
3
3 / "
4
3/8"
3/16"
www.desatech.com
16. Position wall switch assembly vertically over
wall openings with decal lettering upright (see
Figure 13).
17. Insert mounting screws, removed in step
2 of Relocating Wall Switch Assembly on
page 10, through holes in wall plate and
into wall anchors.
18. Tighten screws until wall plate is firmly at-
tached to wall. Do not overtighten.
Figure 13 - Securing Wall Switch
Assembly
Opening in Wall
or Mantel Wall
Wall Switch
Assembly
Screws
111245-01B